• 4300 Adams Rite electrified or mechanical deadlatch, aluminum doors

*Actual product and finish may vary

Steel Hawk - Adams Rite 4300 Series Electrified or Mechanical Deadlatch For Aluminum Stile Doors - ANSI/BHMA Type E8231 (Grade 1)

Patented Non-Handed Latchbolt

Adams Rite Steel Hawk Installation Video

Adams Rite Steel Hawk information


Cylinder Backset - 31/32", 1-1/8" and 1-1/2"

Monitoring - With or Without Monitoring Switch

Function - The 4300 eLatch combines mechanical locking hardware with electrified access control while working within standard aluminum entrance door preparations. Always operable from the inside via handle or paddle device. Entry via keyed mortise cylinder or access control element. Fail-secure lock with optional form “C” latch status monitor. The standard 4300 operates on 12, 16 or 24 volt DC power, and is rated for continuous duty. Units are equipped with a quick connect plug-in type connector. Interchangeable without stile modification for MS® Deadbolts or 4500/4900 Deadlatches.

Case - Steel with corrosion-resistant plating.15/16" x 5-13/16" x depth.

Latchbolt - 5/8" x 1" x 5/8" throw. Stainless steel.

Auxiliary Bolt - All metal. Deadlocks latchbolt to prevent ”loiding” or tampering.

Faceplates - 1" x 6-7/8". Both flat and radius faceplates are supplied. Flat faceplates can also be adjusted in the field for right or left beveled edge doors.

Strikes - Pick from optional strikes. 4304 no-cut surface mounted strike for easy retrofits. Specify mortised-flush versions 4901 when covering existing MS® deadbolt preparation or for new applications. 4901 is available with radius profiles for pairs of doors, and with extended lips of center-hung or thick door applications.  

Operation - Turn key, apply voltage, or operate handle or paddle to release the spring-loaded latchbolt. Electrically rated for continuous duty for timed applications. Interface with access control. Uses any standard mortise cylinder with MS® cam. 1-3/4" minimum door thickness required.

Cylinder Cam - 4300 Series Deadlatches are operable by any standard 1-5/32" diameter mortise cylinder with special MS® cam dimensioned. Cylinders with MS® cams can be readily obtained from most cylinder manufacturers.

VOLTAGE - Field selectable to match power source of 12, 16 or 24 VAC/VDC

Write a review

Note: HTML is not translated!
    Bad           Good

4300 Adams Rite electrified or mechanical deadlatch, aluminum doors

  • $230.00

Available Options

Related Products

7161 TK2 Ilco Thumbturn Mortise 1", AR Cam, Collar

7161 TK2 Ilco Thumbturn Mortise 1", AR Cam, Collar

The Ilco 7161 TK2 is a 1” Thumbturn Mortise Cylinder with an Adams Rite cam, collar. Mortise Cyl..


20-013 Schlage Mortise Cylinder - 1-1/8" x AR Cam

20-013 Schlage Mortise Cylinder - 1-1/8" x AR Cam

The Schlage 20-013 is a conventional (standard) 1-1/8” x AR cam Mortise Cylinder for use with Adams ..